IPEX MHF1 is the original generation of the MHF ultra-miniature push-on connector family, used on early laptop Wi-Fi car
Reverse polarity SMA right angle connector used on older Wi-Fi routers and access points. The right angle version routes
SMA edge mount connectors solder directly to the edge of a PCB with the mating interface extending beyond the board. Use
SMA vertical mount (end launch) connectors solder vertically to PCB holes or pads with the mating interface pointing str
SMA right angle female (jack) connector for cable assemblies where the connector body exits perpendicular to the mating
SMA right angle male connector allows the cable to exit at 90 degrees from the mating face, used when mounting to PCBs o
Right-angle N-type connectors allow perpendicular cable routing for base station equipment, outdoor wireless APs, and RF
PL-259 (male) and SO-239 (female) are the standard amateur radio connectors for HF, VHF, and UHF antennas. Performance d
GT5 (IEC 61169-58) is an updated FAKRA-compatible automotive RF connector supporting up to 6 GHz for 5G vehicle antennas
The 1.85mm V connector operates to 67 GHz for 77GHz automotive radar and highest-frequency test equipment. Extremely pre
The 7-16 DIN is a large robust coaxial connector rated to 7.5 GHz and 4 kW for cellular base station antennas and high-p
The 4.3-10 is a smaller alternative to 7-16 DIN rated to 6 GHz for 4G/5G small cell antennas with hand-tightenable desig
QMA is a quick-lock SMA-compatible connector with push-on quarter-turn release for distributed antenna systems requiring
SMP (SubMiniature Push-on) is a snap-on 50-ohm connector rated to 40 GHz for microwave assemblies and phased array anten
FAKRA (DIN 72594-1) color-coded coaxial connectors for automotive GPS, AM/FM, DAB, and vehicle camera antenna connection
HSD connectors provide both RF and differential LVDS data in one connector for automotive displays and camera connection
SMA female panel-mount connector bolted to enclosures for antenna connections on Wi-Fi routers, SDR devices, and test eq
RP-TNC is a TNC connector with reversed center pin gender. Used on older Cisco and Linksys Wi-Fi equipment with threaded
TNC (Threaded Neill-Concelman) is the threaded version of BNC providing better performance at microwave frequencies for
SMB (SubMiniature version B) is a snap-on coaxial connector rated to 4 GHz, smaller than BNC, used in GPS, cellular, and
MMCX is a very small snap-on RF connector rated to 6 GHz used on Wi-Fi cards, GPS modules, and wireless devices where sp
MHF4 (also AMC or W.FL) is an ultra-miniature push-on RF connector even smaller than U.FL used on M.2 wireless cards and
The 2.92mm K connector operates to 40 GHz and mates with SMA. Used in mmWave test equipment, 5G components, and radar sy
The 2.4mm connector operates to 50 GHz for high-frequency test equipment and mmWave 5G applications.