SAE J1772 Type 1 charging inlet is the North American standard for single-phase Level 1 and Level 2 AC charging on vehic
IEC 62196 Type 2 (Mennekes) charging inlet is the European standard for EV charging allowing single-phase up to 7.4kW an
Automotive short and long range radar sensors use FAKRA or HSD connectors for antenna connections plus M8 or M12 connect
Automotive LiDAR sensors from Velodyne, Ouster, and Hesai use M12 or proprietary circular connectors for power, Ethernet
UDS (Unified Diagnostic Services, ISO 14229) runs over CAN on the OBD-II connector for modern vehicle diagnostics, ECU f
FAKRA blue-coded connectors are designated for GPS antenna connections in vehicles, providing the standard interface for
ADAS camera modules use FAKRA, HSD, or USCAR-30 coaxial connectors for LVDS or GMSL video signals combined with power an
Electric vehicle traction motor connectors handle 3-phase AC at 400V or 800V and currents up to 800A. Proprietary housin
CAN bus DB9 connector (CiA 303-1) is the standard for industrial CANopen connections providing CAN high, CAN low, ground
The ELM327 is the most popular OBD-II interpreter chip used in Bluetooth and Wi-Fi OBD-II dongles, translating between O
Sumitomo HM (High temperature Multi-purpose) connectors are used throughout Japanese vehicle engine bays where temperatu
The camshaft position sensor (CMP) uses a 3-pin Hall effect connector to detect cam lobe position for sequential fuel in
The ABS wheel speed sensor uses a 2-pin connector for passive (magnetic VR) or active (Hall effect) wheel speed signals
Parking distance control (PDC) ultrasonic sensors use a 3-pin connector for power, ground, and a combined signal line th
The MAP (Manifold Absolute Pressure) sensor uses a 3-pin connector for power, ground, and analog voltage output proporti
The coolant temperature sensor (CLT/ECT) uses a 2-pin connector carrying a thermistor signal that changes resistance wit
The knock sensor uses a piezoelectric element to detect engine knock vibrations. The 2-pin connector carries the sensor
Bosch hot-wire MAF (Mass Airflow Sensor) uses a 5-pin connector carrying power, ground, signal output, temperature outpu
The throttle position sensor (TPS) is a 3-pin rotary potentiometer connector providing a 0-5V output proportional to thr
Bosch 4-pin lambda (oxygen) sensor connector carries heater power and the Nernst cell signal wires. The heater brings th
The crankshaft position sensor (CKP) uses a 3-pin connector carrying 5V or 12V supply, ground, and a signal line produci
The OPEN Alliance 100BASE-T1 (BroadR-Reach) uses Rosenberger HSD or MATEnet connectors for single-pair automotive Ethern
FAKRA Z code (black housing) is specifically designated for video camera signals in automotive applications, used for re
Ford EEC-IV (Electronic Engine Control IV) uses a 60-pin connector on the ECM for all engine management I/O. Used on For